Programming Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 Entering the Programming Mode
- 4.2 Exiting the Programming Mode
- 4.3 Changing the Open Code
- 4.4 Changing the Auxiliary Code
- 4.5 Changing the Programming Code
- 4.6 Changing the Normal/Secure Code
- 4.7 Changing the Normal/Bypass Code
- 4.8 Setting Fail Safe/Secure Operation, Tamper Siren and Lock Strike Release Time
- 4.9 Setting Auxiliary Modes
- 4.10 Keypad Heater Operation
- 4.11 Setting the Lockout Feature
- 4.12 Setting the Backlight Behavior
- 4.13 Enrolling Primary and Secondary Codes
- 4.14 Deleting Primary and Secondary Codes
- 4.15 Relay Codes Assignment
- 4.16 Changing PIN Code Length/Factory Default Settings
- 4.17 Replacing a Programming Code
- 4.18 Replacing a Normal/Secure Code
- 5. Technical Specifications
Table of Contents
AC-Q4x Series Installation and Programming Manual v
4.13.1 Primary Codes Definition .................................................................43
4.13.2 Secondary Codes Definition ............................................................44
4.13.3 Enrolling Methods ............................................................................44
4.14 Deleting Primary and Secondary Codes .................................. 47
4.14.1 Deleting Primary and Secondary Codes using the Standard
Method ..............................................................................................47
4.14.2 Deleting Primary and Secondary Codes using the Code Search
Method ..............................................................................................48
4.15 Relay Codes Assignment ......................................................... 49
4.15.1 Relay Code Assignment using Standard Method .........................49
4.15.2 Relay Code Assignment using Search Method .............................50
4.16 Changing PIN Code Length/Factory Default Settings ............. 52
4.17 Replacing a Programming Code .............................................. 53
4.18 Replacing a Normal/Secure Code ........................................... 53
5. Technical Specifications ..................................................... 54
A. Declaration of Conformity ................................................... 56
B. Limited Warranty ................................................................. 57