Programming Manual

Programming
28 AC-Q4x Series Installation and Programming Manual
4. Programming
• In the Programming chapter, “code” refers to a PIN code or
proximity card depending on the unit you have.
• When entering a PIN or presenting a proximity card is mentioned,
the meaning may vary between units.
Programming is done solely via the unit’s keypad-driven
Programming Menu System. To reach the Programming Menu
System, the controller must first be placed into Programming Mode
(see Section 4.1
).
During the manufacturing process, certain codes and settings are
pre-programmed. These settings are the called default factory
settings.
Table 2 shows all the programming menus, with default factory
codes and settings.
Table 2: Programming Menus
Menu
No.
Description Default Section
4
Digits
5
Digits
6
Digits
4-8 Digits
1 Change Open code 2580 25802 258025 25802580 4.3
2 Change Auxiliary code 0852 08520 085208 08520852 4.4
3 Change Program code 1234 12341 123412 12341234 4.5
4 Change Normal/Secure
code
3838 38383 383838 38383838 4.6
5 Change Normal/Bypass
code
NA 4.7
6 Change Door Release time 0004 4.8
Define auxiliary
inputs/outputs
2004 4.9
Enable or disable keypad
heater
3000 4.10
Set Lockout Feature 4000 4.11