Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Programming
AC-F/G4x Series Installation and Programming Manual 59
If the user slot is empty, you hear a long beep and the unit
returns to Normal mode.
4.
Enter your 4-digit Programming code to
confirm the deletion.
If the Programming code is valid, three beeps are heard and
the controller returns to Normal mode.
If the Programming code is invalid, a long beep is heard and
the controller returns to Normal mode.
5.13.2 Deleting Primary and Secondary Codes using
the Code Search Method
To delete the Primary and Secondary codes using the Code
Search Method:
5.
Enter Programming mode.
6.
Press 8 to enter Menu 8.
The left LED turns red and the right LED
turns orange.
7.
Enter 000 as the 3-digit user slot number.
The right LED flashes orange.
The controller is now waiting for the Primary code of the
user you want to delete.
Red
Orange
Red
Orange
Green