Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Programming
58 AC-F/G4x Series Installation and Programming Manual
5.13
Deleting Primary and Secondary Codes
There are two methods to delete Primary and Secondary codes:
a standard method and a search method. When deleting a user
slot, both the primary code and the secondary code are erased.
It
is recommended that a record be kept of added and
deleted users
. This makes it easier to keep track of user
slots
’ status (empty or not).
5.13.1 Deleting Primary and Secondary Codes using
the Standard Method
To delete the Primary and Secondary codes using the
Standard Method:
1.
Enter Programming mode.
2.
Press 8 to enter Menu 8.
The left LED turns red and the right LED
turns orange.
3.
Enter the 3-digit User Slot code you wish
to delete.
The left LED flashes red indicating the
controller is waiting for the Programming
code to confirm the deletion.
Red
Orange
Red
Orange
Green