Instruction manual

1
2
3
4
5
6
7
8
9
0
#
Door LED
3 x 4 Matrix Keypad
Mode LED
Case Screw
Bell Button
(With BL-D40)
Page 9
07/04
Installation
Mounting the AC-Q41H Controller
1) Before starting, select the location to mount the AC-Q41H
controller.
2) Drill holes into the back cover according to how you want to
mount the AC-Q41H. (See explanation and diagram below).
US Gang Box
There are two hole indicators on the back of the metal cover
specifically for the US Gang Box. (Shown marked as A)
4 Screw Custom
There are four indicators on the back. (Shown marked as B)
3) Drill the exit/entry holes for the wiring. (Shown marked as C)
4) Pass the wires through the exit/entry holes and attach them to
the controllers removable terminal blocks as shown in the
diagram on the next page.
AC-Q41H
A
A
B
B
B
B
C
CAUTION!
DO NOT DRILL
This is the Tamper Lens