Instruction manual

Installation
AC-Q4x Family, Installation and user Manual Page 10
3) Use the provided drilling template to accurately locate and
drill the required holes in the wall or panel.
4) Use the hardware provided to mount the back plate on the
wall or on a gang box. Be sure to route the wiring via the
large center hole in the back plate. Check for level.
5) Wire the controller according to the type supplied: pre-wired
cable or terminal block terminal, as instructed hereafter.
6) Once wired, replace the controller back onto its back plate
and secure using tamper-proof screw and special tool,
supplied with the hardware.
2.2 WIRING THE CONTROLLER
The controllers are provided either with a sixty-centimeter, pre-
wired, 10-conductor cable or with a screw-type terminal block.
Specifically:
Pre-wired cabling Models Terminal block models
AC-Q41SB AC-Q41H/HB
AC-Q42SB AC-Q42H/HB
AC-Q44
2.2.1 Pre-wired Models
These controllers come with a 60cm 24-AWG wiring.
Wire according to the following steps:
1) Cut and strip the conductors to the necessary length.
2) Splice the controller pigtail wires to the corresponding
ancillary devices and insulate each connection, including
unused wires. Refer to the wiring color guide table below and
to the wiring diagrams, depending on the desired
application:
Wiring the Lock Strike Relay & REX (
Figure 3)
Wiring for Auxiliary Input & Output (Figure 4)
Wiring for the BL-D40 External Sounder (
Figure 5)