Instruction manual
Table Of Contents
- 1. General Information
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 INTRODUCTION
- 4.2 CHANGING THE OPEN CODE
- 4.3 CHANGING THE AUXILIARY CODE
- 4.4 CHANGING THE PROGRAMMING CODE
- 4.5 CHANGING THE NORMAL/SECURE CODE
- 4.6 CHANGING THE NORMAL/BYPASS CODE
- 4.7 SETTING FAILSAFE/SECURE OPERATION
- 4.8 SETTING AUXILIARY MODES
- 4.9 SETTING THE LOCKOUT FEATURE
- 4.10 BACKLIGHT and LED BEHAVIOR
- 4.11 ENROLLING CODES
- 4.12 DELETING CODES
- 4.13 RELAY CODES ASSIGNMENT
- 4.14 PIN CODE LENGTH / FACTORY DEFAULT SETTINGS
- 4.15 REPLACING A PROGRAMMING CODE
- 4.16 REPLACING A NORMAL/SECURE CODE
- Appendix A.
- Appendix A. Limited Warranty
- Appendix B.
- Appendix B. Technical Support
General Information
AC-F4x and AC-G4x Family Manual
Page 5
1.3 BOX CONTENT
Before beginning verify that all of the following is in the box, if
anything is missing please report the discrepancy to your nearest
Rosslare Office.
• One unit
• One Drilling Template (Label/Sticker)
• One security spline key
• One security hex screw
• Four mounting screws and wall plugs
1.4 ANCILLARY EQUIPMENT
The following ancillary equipment may be required to complete
your installation:
• Electric Lock Strike Mechanism - fail safe (power to lock) or
fail secure (power to open).
• Power Supply with Backup Battery - 12 to 24 VDC (from a
regulated power supply) or 16 to 24 VAC (from a
transformer).
• Request to Exit (REX) Button (optional) - normally open
type; switch is closed when pressed.
• BL-D40 External Sounder (optional) - provides siren, bell,
and chime.
• Magnetic Contact (optional) - installed for door monitor
capabilities.
Other Rosslare accessories can be found at Rosslare's Web Site:
www.rosslaresecurity.com