Instruction manual
Table Of Contents
- 1. General Information
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 INTRODUCTION
- 4.2 CHANGING THE OPEN CODE
- 4.3 CHANGING THE AUXILIARY CODE
- 4.4 CHANGING THE PROGRAMMING CODE
- 4.5 CHANGING THE NORMAL/SECURE CODE
- 4.6 CHANGING THE NORMAL/BYPASS CODE
- 4.7 SETTING FAILSAFE/SECURE OPERATION
- 4.8 SETTING AUXILIARY MODES
- 4.9 SETTING THE LOCKOUT FEATURE
- 4.10 BACKLIGHT and LED BEHAVIOR
- 4.11 ENROLLING CODES
- 4.12 DELETING CODES
- 4.13 RELAY CODES ASSIGNMENT
- 4.14 PIN CODE LENGTH / FACTORY DEFAULT SETTINGS
- 4.15 REPLACING A PROGRAMMING CODE
- 4.16 REPLACING A NORMAL/SECURE CODE
- Appendix A.
- Appendix A. Limited Warranty
- Appendix B.
- Appendix B. Technical Support
Programming
AC-F4x and AC-G4x Family Manual Page 46
4.15 REPLACING A PROGRAMMING CODE
Note:
The controller must be in its normal mode for the procedure
to work. Insure that the Mode indicator is green before
proceeding.
1) Remove power from the controller.
2) Depress and hold the REX pushbutton.
3) Apply power to the unit with the REX pushbutton depressed.
4) Release the REX pushbutton.
5) You now have 15 seconds to program a new programming
code into the unit using the initial default code, before the
controller reverts to the existing code.
the deafult code depends on the pin length selected, reffer
to the
programming Menu table on page 22.
4.16 REPLACING A NORMAL/SECURE CODE
Note:
The controller must be in its secure mode for the procedure
to work. Insure that the Mode indicator is red before
proceeding.
1) Remove power from the controller.
2) Depress and hold the REX pushbutton.
3) Apply power to the unit with the REX pushbutton depressed.
4) Release the REX pushbutton.
5) You now have 15 seconds to use the normal/secure code to
return to the normal mode. Once in the normal mode, enter
the programming mode to program a new normal/secure
code.
the deafult code depends on the pin length selected, reffer
to the programming Menu table on page 22.