Instruction manual
Table Of Contents
- 1. General Information
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 INTRODUCTION
- 4.2 CHANGING THE OPEN CODE
- 4.3 CHANGING THE AUXILIARY CODE
- 4.4 CHANGING THE PROGRAMMING CODE
- 4.5 CHANGING THE NORMAL/SECURE CODE
- 4.6 CHANGING THE NORMAL/BYPASS CODE
- 4.7 SETTING FAILSAFE/SECURE OPERATION
- 4.8 SETTING AUXILIARY MODES
- 4.9 SETTING THE LOCKOUT FEATURE
- 4.10 BACKLIGHT and LED BEHAVIOR
- 4.11 ENROLLING CODES
- 4.12 DELETING CODES
- 4.13 RELAY CODES ASSIGNMENT
- 4.14 PIN CODE LENGTH / FACTORY DEFAULT SETTINGS
- 4.15 REPLACING A PROGRAMMING CODE
- 4.16 REPLACING A NORMAL/SECURE CODE
- Appendix A.
- Appendix A. Limited Warranty
- Appendix B.
- Appendix B. Technical Support
Programming
AC-F4x and AC-G4x Family Manual Page 26
4.5 CHANGING THE NORMAL/SECURE CODE
Note:
• When the auxiliary mode is 1, 2, 3 or 4, the auxiliary input takes
priority over the normal/secure code.
• Wrong entries: you will hear a long beep and the controller will
return to its normal mode.
• Code 0000 will erase and deactivate the normal/secure code.
1) Enter the programming mode.
2) Depress 4 to enter Menu 4.
• The Mode indicator will flash red.
3) Enter the new Normal/Secure code.
4) System returns to its normal mode.
• You will hear three beeps.
• The Door indicator will turn off.
• The Mode indicator will turn green.
4.6 CHANGING THE NORMAL/BYPASS CODE
The normal / bypass code is also used to turn the door chime off
and on. Chime only functions with the BL-D40 External Sounder.
Note:
• The chime is only heard when the Lock Strike relay is activated
by a valid code entry.
• Wrong entries: you will hear a long beep and the controller will
return to its normal mode.
• Code 0000 will erase and deactivate the normal/bypass code.
1) Enter the programming mode.
2) Depress 5 to enter Menu 5.
• The Mode indicator will flash orange.
Mode Door
Green
Mode
Door
Red Green
Mode Door
Green
Mode
Door
Green
Mode
Door
Orange
Green