Instruction manual
Table Of Contents
- 1. General Information
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 INTRODUCTION
- 4.2 CHANGING THE OPEN CODE
- 4.3 CHANGING THE AUXILIARY CODE
- 4.4 CHANGING THE PROGRAMMING CODE
- 4.5 CHANGING THE NORMAL/SECURE CODE
- 4.6 CHANGING THE NORMAL/BYPASS CODE
- 4.7 SETTING FAILSAFE/SECURE OPERATION
- 4.8 SETTING AUXILIARY MODES
- 4.9 SETTING THE LOCKOUT FEATURE
- 4.10 BACKLIGHT and LED BEHAVIOR
- 4.11 ENROLLING CODES
- 4.12 DELETING CODES
- 4.13 RELAY CODES ASSIGNMENT
- 4.14 PIN CODE LENGTH / FACTORY DEFAULT SETTINGS
- 4.15 REPLACING A PROGRAMMING CODE
- 4.16 REPLACING A NORMAL/SECURE CODE
- Appendix A.
- Appendix A. Limited Warranty
- Appendix B.
- Appendix B. Technical Support
Programming
AC-F4x and AC-G4x Family Manual
Page 25
Note:
• Auxiliary code does not function in secure mode.
• Auxiliary code only works when the auxiliary mode is 0, 1, 8 or 9.
• Wrong entries: you will hear a long beep and the controller will
return to its normal mode.
• Code 0000 will erase and deactivate the auxiliary code.
1) Enter the programming mode.
2) Depress 2 to enter Menu 2.
• The Mode indicator will turn orange.
3) Enter a new auxiliary code.
4) System returns to its normal mode.
• You will hear three beeps.
• The Door indicator will turn off.
• The Mode indicator will turn green.
4.4 CHANGING THE PROGRAMMING CODE
Note:
• The code 0000 is not valid; thus, the programming code cannot
be erased.
• Wrong entries: you will hear a long beep and the controller will
return to its normal mode.
1) Enter the programming mode.
2) Depress 3 to enter Menu 3.
• The Mode indicator will turn green.
3) Enter the new programming code.
4) System returns to its normal mode.
• You will hear three beeps.
• The Door indicator will turn off.
• The Mode indicator will turn green.
Mode
Door
Green
Mode
Door
Oran
g
e Green
Mode
Door
Green
Mode
Door
Green
Mode
Door
Green
Green
Mode
Door
Green