Instruction manual
Table Of Contents
- 1. General Information
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 INTRODUCTION
- 4.2 CHANGING THE OPEN CODE
- 4.3 CHANGING THE AUXILIARY CODE
- 4.4 CHANGING THE PROGRAMMING CODE
- 4.5 CHANGING THE NORMAL/SECURE CODE
- 4.6 CHANGING THE NORMAL/BYPASS CODE
- 4.7 SETTING FAILSAFE/SECURE OPERATION
- 4.8 SETTING AUXILIARY MODES
- 4.9 SETTING THE LOCKOUT FEATURE
- 4.10 BACKLIGHT and LED BEHAVIOR
- 4.11 ENROLLING CODES
- 4.12 DELETING CODES
- 4.13 RELAY CODES ASSIGNMENT
- 4.14 PIN CODE LENGTH / FACTORY DEFAULT SETTINGS
- 4.15 REPLACING A PROGRAMMING CODE
- 4.16 REPLACING A NORMAL/SECURE CODE
- Appendix A.
- Appendix A. Limited Warranty
- Appendix B.
- Appendix B. Technical Support
Programming
AC-F4x and AC-G4x Family Manual
Page 23
Mode
Door
Red
4.1.1 Entering the Programming Mode
Note:
• The controller must be in normal mode to enter the
programming mode.
• The factory default 4-digit programming code is 1234.
• If a programming code is not entered within 5 seconds, the
controller will return to its normal mode.
1) Depress the # key twice, within 0.5 seconds.
• Mode indicator will turn off.
• Door indicator will turn red.
2) Enter your programming code.
If the programming code is valid, the door
Indicator will turn green and the controller will
enter the programming mode.
4.1.2 Exiting the Programming Mode
Note:
• Wrong entries may reset the controller back to its normal mode.
• If no key is pressed for 1 minute, while in programming mode,
the controller will exit the programming mode and return to its
normal mode.
To exit the programming mode, depress the # key twice, within 0.5
seconds.
• You will hear three beeps.
• The door indicator will be off.
• The mode indicator will turn green.
The above indicates that the controller has returned to its normal
mode.
Note:
While enrolling, deleting users, or while in code assignment
mode, depress the # key, twice to exit the programming mode.
Mode
Door
Green
Mode Door
Green