Instruction manual
Table Of Contents
- 1. General Information
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 INTRODUCTION
- 4.2 CHANGING THE OPEN CODE
- 4.3 CHANGING THE AUXILIARY CODE
- 4.4 CHANGING THE PROGRAMMING CODE
- 4.5 CHANGING THE NORMAL/SECURE CODE
- 4.6 CHANGING THE NORMAL/BYPASS CODE
- 4.7 SETTING FAILSAFE/SECURE OPERATION
- 4.8 SETTING AUXILIARY MODES
- 4.9 SETTING THE LOCKOUT FEATURE
- 4.10 BACKLIGHT and LED BEHAVIOR
- 4.11 ENROLLING CODES
- 4.12 DELETING CODES
- 4.13 RELAY CODES ASSIGNMENT
- 4.14 PIN CODE LENGTH / FACTORY DEFAULT SETTINGS
- 4.15 REPLACING A PROGRAMMING CODE
- 4.16 REPLACING A NORMAL/SECURE CODE
- Appendix A.
- Appendix A. Limited Warranty
- Appendix B.
- Appendix B. Technical Support
Programming
AC-F4x and AC-G4x Family Manual
Page 21
4. Programming
Note:
• In the Programming chapter, “code” refers to a PIN code or
proximity card depending on the unit you have.
• When entering a PIN or presenting a proximity card is
mentioned, the meaning may vary between units.
4.1 INTRODUCTION
Programming the Access Control unit is done solely via the unit’s
keypad-driven Programming Menu System. To reach the
Programming Menu System, the controller must first be placed into
Programming Mode. Refer to Entering Programming Mode,
paragraph 4.1.1
During the manufacturing process, certain codes and settings are
pre-programmed. These settings are the called default factory
settings.