Instruction manual
Table Of Contents
- 1. General Information
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 INTRODUCTION
- 4.2 CHANGING THE OPEN CODE
- 4.3 CHANGING THE AUXILIARY CODE
- 4.4 CHANGING THE PROGRAMMING CODE
- 4.5 CHANGING THE NORMAL/SECURE CODE
- 4.6 CHANGING THE NORMAL/BYPASS CODE
- 4.7 SETTING FAILSAFE/SECURE OPERATION
- 4.8 SETTING AUXILIARY MODES
- 4.9 SETTING THE LOCKOUT FEATURE
- 4.10 BACKLIGHT and LED BEHAVIOR
- 4.11 ENROLLING CODES
- 4.12 DELETING CODES
- 4.13 RELAY CODES ASSIGNMENT
- 4.14 PIN CODE LENGTH / FACTORY DEFAULT SETTINGS
- 4.15 REPLACING A PROGRAMMING CODE
- 4.16 REPLACING A NORMAL/SECURE CODE
- Appendix A.
- Appendix A. Limited Warranty
- Appendix B.
- Appendix B. Technical Support
Operation
AC-F4x and AC-G4x Family Manual
Page 17
3.3.2 From Secure to Normal Mode
The default factory setting for the normal / secure code is 3838.
1) Enter the normal / secure code.
• Mode indicator will flash green.
2) Depress the # key to confirm the Mode
change.
• Mode indicator will turn green.
The auxiliary input of the controller can also be used to switch the
mode of operation from secure to normal and vice versa, if the
auxiliary input is selected it de-activates the Norma/Secure mode
code. Refer to Setting the Auxiliary Mode, paragraph
4.8.
3.3.3 From Normal to Bypass Mode
By default, there is no normal / bypass code. The normal / bypass
code must first be programmed to use this function. Refer to
paragraph 4.6 to create / modify the normal / bypass code.
1) Enter the normal / bypass code.
• Mode indicator will flash orange.
2) Depress the # key to confirm the mode
change.
• Mode indicator will turn orange.
Mode
Door
Red
Mode
Door
Green
Mode
Door
Green
Mode
Door
Green
Mode
Door
Orange
Mode
Door
Orange