Instruction manual
Table Of Contents
- 1. General Information
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 INTRODUCTION
- 4.2 CHANGING THE OPEN CODE
- 4.3 CHANGING THE AUXILIARY CODE
- 4.4 CHANGING THE PROGRAMMING CODE
- 4.5 CHANGING THE NORMAL/SECURE CODE
- 4.6 CHANGING THE NORMAL/BYPASS CODE
- 4.7 SETTING FAILSAFE/SECURE OPERATION
- 4.8 SETTING AUXILIARY MODES
- 4.9 SETTING THE LOCKOUT FEATURE
- 4.10 BACKLIGHT and LED BEHAVIOR
- 4.11 ENROLLING CODES
- 4.12 DELETING CODES
- 4.13 RELAY CODES ASSIGNMENT
- 4.14 PIN CODE LENGTH / FACTORY DEFAULT SETTINGS
- 4.15 REPLACING A PROGRAMMING CODE
- 4.16 REPLACING A NORMAL/SECURE CODE
- Appendix A.
- Appendix A. Limited Warranty
- Appendix B.
- Appendix B. Technical Support
Installation
AC-F4x and AC-G4x Family Manual Page 10
6) Once wired, replace the controller back onto its back plate
and secure using tamper-proof screw and special tool,
supplied with the hardware.
2.2 WIRING THE CONTROLLER
The controllers are provided with a one-meter, pre-wired, 10-
conductor 18 AWG cable
Wire according to the following steps:
1) Cut and strip the conductors to the necessary length.
2) Splice the controller pigtail wires to the corresponding
ancillary devices and insulate each connection, including
unused wires. Refer to the wiring color guide table and to the
wiring diagrams, depending on the desired application:
Wiring the Lock Strike Relay & REX (Figure 3)
Wiring for Auxiliary Input & Output (Figure 4)
Wiring for the BL-D40 External Sounder (Figure 5)
Wiring Color Guide
Color Description
Red V input
Black Ground
Green REX / BL
White In / Monitor
Purple Lock: Com
Gray Lock: N.O.
Brown Lock: N.C.
Blue Aux: Com
Yellow Aux: N.O.
Orange Aux: N.C.