Instruction manual
Table Of Contents
- 1. General Information
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 INTRODUCTION
- 4.2 CHANGING THE OPEN CODE
- 4.3 CHANGING THE AUXILIARY CODE
- 4.4 CHANGING THE PROGRAMMING CODE
- 4.5 CHANGING THE NORMAL/SECURE CODE
- 4.6 CHANGING THE NORMAL/BYPASS CODE
- 4.7 SETTING FAILSAFE/SECURE OPERATION
- 4.8 SETTING AUXILIARY MODES
- 4.9 SETTING THE LOCKOUT FEATURE
- 4.10 BACKLIGHT and LED BEHAVIOR
- 4.11 ENROLLING CODES
- 4.12 DELETING CODES
- 4.13 RELAY CODES ASSIGNMENT
- 4.14 PIN CODE LENGTH / FACTORY DEFAULT SETTINGS
- 4.15 REPLACING A PROGRAMMING CODE
- 4.16 REPLACING A NORMAL/SECURE CODE
- Appendix A.
- Appendix A. Limited Warranty
- Appendix B.
- Appendix B. Technical Support
Installation
AC-F4x and AC-G4x Family Manual
Page 9
2. Installation
2.1 MOUNTING THE CONTROLLER
Prior to starting, select the location where the controller unit is to
be mounted. Perform the following steps:
1) Open the controller by loosening and removing the case
security screw at the bottom using the security spline key.
2) Depending on the type of installation, gang box or panel
mount, drill the respective holes in the rear cover.
Figure 2: Drilling Holes Identification
Note:
The central hole is for routing the wiring to the controller.
3) Use the provided drilling template to accurately locate and
drill the required holes in the wall or panel.
4) Use the hardware provided to mount the back plate on the
wall or on a gang box. Be sure to route the wiring via the
large center hole in the back plate. Check for level.
5) Wire the controller's pre-wired cable as instructed hereafter.