User guide
Table Of Contents
- 1. Introduction
- 2. Specifications and Requirements
- 3. Installation
- 4. System Overview
- 5. How to Set Up a Site
- 5.1 Adding Time Zones
- 5.2 Adding Holidays
- 5.3 Adding a Network
- 5.4 Adding Access Control Panels
- 5.5 Configuring the Doors
- 5.6 Configuring the Readers
- 5.7 Configuring the Inputs
- 5.8 Adding a Camera
- 5.9 Adding Panel Links
- 5.10 Creating Groups
- 5.11 Adding Users and Cards
- 5.12 Adding Departments, Users, and Visitors
- 5.13 Adding Access Areas
- 5.14 Adding Global Antipassback Rules
- 5.15 Car Parking
- 5.16 Adding Operators
- 5.17 Creating Elevator Control
- 5.18 Creating Status Maps
- 6. ViTrax™ Video Integration
- 7. Manual Operation
- 8. AxTraxNG™ Reports
- 9. Administrator Operations
- A. Firewall Configuration
- B. SQL Service Settings
- C. Network Configuration
- D. Restoring Factory Default Settings
- E. Configuring User Counters
- F. Cross Platform Camera Setup
- G. Enrolling Cards using MD-08 Desktop Reader
- H. SQL Server Installation Troubleshoot
- I. AxTrax.NET Watchdog
- J. Adding Custom Wiegand Formats
ViTrax™ Video Integration
92 AxTraxNG™ Software Installation and User Manual
4. Select the Popup Enabled checkbox to enable local pop-up messages.
5. Under
Close window options,
select either Manually or By timer.
6. Click OK.
6.6.3 Camera Event
Create camera event based automatic camera activation.
To create camera event based camera activation:
1. Open the
Camera Properties
window (see Section 6.5).
2. Click Options.
The
Video Popup and Snapshot
window opens.
3. Select the Popup Camera Window on ViTrax recording checkbox to
enable window pop-up on the PC during camera’s ViTrax™ recording.
4. Select the Popup Window on Motion detected start checkbox to
enable window pop-up on the PC following an activation of the ViTrax™
Motion detection.
5. Under
Close window options,
select either Manually or By timer.
6. Click OK.
6.6.4 Door Warning Event
Create a door-warning event based automatic camera activation.
The available door warnings in the system are Door held open and Door
forced open.
To create door-warning event based camera activation:
1. Open the
Door
window (see Section 5.5).
2. Select the Door held open and/or the Door forced open options, and
define their associated timer.
The
Enable Cameras Options by Door Warning Events
pane opens within
the
Door
window.