User guide
Table Of Contents
- 1. Introduction
- 2. Specifications and Requirements
- 3. Installation
- 4. System Overview
- 5. How to Set Up a Site
- 5.1 Adding Time Zones
- 5.2 Adding Holidays
- 5.3 Adding a Network
- 5.4 Adding Access Control Panels
- 5.5 Configuring the Doors
- 5.6 Configuring the Readers
- 5.7 Configuring the Inputs
- 5.8 Adding a Camera
- 5.9 Adding Panel Links
- 5.10 Creating Groups
- 5.11 Adding Users and Cards
- 5.12 Adding Departments, Users, and Visitors
- 5.13 Adding Access Areas
- 5.14 Adding Global Antipassback Rules
- 5.15 Car Parking
- 5.16 Adding Operators
- 5.17 Creating Elevator Control
- 5.18 Creating Status Maps
- 6. ViTrax™ Video Integration
- 7. Manual Operation
- 8. AxTraxNG™ Reports
- 9. Administrator Operations
- A. Firewall Configuration
- B. SQL Service Settings
- C. Network Configuration
- D. Restoring Factory Default Settings
- E. Configuring User Counters
- F. Cross Platform Camera Setup
- G. Enrolling Cards using MD-08 Desktop Reader
- H. SQL Server Installation Troubleshoot
- I. AxTrax.NET Watchdog
- J. Adding Custom Wiegand Formats
Configuring User Counters
120 AxTraxNG™ Software Installation and User Manual
E. Configuring User Counters
You can use the User Counter options to limit the number of entrances of a
particular user. This is done using the Counter option that appears on the
User
Properties
window (Figure 2 in Section 5.12.2).
To configure user counters:
1. Go the
General
tab of the
User Properties
window either as part of the
procedure of adding a new user as described in Section 5.12.2, or select
an existing user in the Departments/Users element and click the
icon.
2. In the Counter section of the
User Properties
window, select the Enable
checkbox.
3. Select the Set new counter checkbox and specify the number of allowed
entrances for the user using the Counter value spin box.
4. Click OK.
5. Go the
General
tab of the
Reader Properties
(Section 5.6).
6. In the Details section, select the Deduct User counter checkbox.
7. Click OK.
E.1 Resetting Counter on Panel Re-enable
There is an additional counter option that allows you to reset the user counter
to its starting value in the event that a panel is disconnected and then
reconnected again.
If this option is not used, then upon panel re-enable, the user counter
continues with its previous value prior to having that panel disabled.
To reset the user counter on panel re-enable:
1. In the Tree View, expand the AC Networks element and select a
network.
2. From the Table View area, select a panel and click the icon.
The
Panel Properties
window opens.
3. Click the
Options
tab.