User guide

Network Configuration
116 AxTraxNG™ Software Installation and User Manual
To initialize and configure the computer modem:
1. In the Network window, click Configuration.
The Modem Configuration window opens.
2. In the Dialing area, under Remote modem phone number, type the
destination telephone number to call.
3. Click to change the Number of dial attempts (if required).
For most applications, the default dialing string is sufficient.
The dialing string is displayed in the window.
4. Clear the Use default checkbox. This allows adding or editing of the
dialing string. Then, type the AT command in the Dialing string window.
5. From the Dialing schedule dropdown list, select the time zone.
6. Choose the disconnecting condition: Disconnect by schedule end or
Disconnect on upload complete.
This option is enabled when the selected time zone is different from the
default time zone (Always and Never).
7. In the Settings area, the initialization string is displayed in the window.
For most applications, the default initialization string is sufficient.
8. Clear the Use default checkbox to allow adding or editing of the dialing
string. Then, type the AT command in the Dialing string window.
9. Connect the computer's modem to the PC via the selected COM port, and
click Apply to initialize the PC modem.
10. Click OK to complete the initialization.
11. If the computer displays a failure message, check the modem connections
and repeat the last steps.
Remote modem initialization is at the PC side. When modem initialization
fails through telephone line, a message appears.