Installation guide

AC-215 Single and Double Door Access Control Unit
Hardware Installation Guide
26
Running the MD-32 configuration Software
1)
Run the PC software: "IIM_CfgTool
"
.
2) Click on the tab: "Search".
Make sure that you see the right MD-N32's MAC Address on
the “Board List” area .
3) Select the MAC Address of the unit that connects to the AC-215.
4) Make sure to empty the "Debug mode" tab (must to do when working with AC-215).
5) At the "Network Configuration" area, type the IP Address and Subnet which the
network administrator supplied you.
6) In the "Channel Configuration" area, leave the "use client mode only" empty.
At the tab of the "Listen Port " type 1000.
At the tab of "Server" type again the same IP Address and the
number of the Port (1000).
7)
In the "Serial Configuration" area type the serial configuration (Usually:
9600/None/8/1/None).
8) Click the "Set Up" tab to send the configuration to the unit.
∗ Configuration Example