Installation manual

Mounting Instructions
Swipe Family Readers Installation Manual Page 9
7. Carefully remove the snap-off front cover of the Reader to
reveal two screw holes.
AY-B1663
AY-B4663
Figure 5: Removing the Top Cover
8. Route the interface cable from the Reader to the
Controller.
Note:
The Reader can also be mounted using strong epoxy glue.
After application, firmly hold the Reader in place until the
glue dries.
9. Carefully re-attach the snap-off front cover of the Reader
and secure the case security screw at the bottom using the
security hex key.