Installation manual

Modes of Operation
Swipe Family Readers Installation Manual Page 13
8 Modes of Operation
Mifare
®
Smart Card Fingerprint Swipe Sensor MOC Readers
have the following modes of operation:
• Boot mode (Reset)
• Configuration Mode
• Standby mode
• Read mode
• Lockout mode
8.1 Boot Mode
The Reader enters Boot mode upon power up or upon
restoration of power after a power failure where the loader
runs separately from the main application. During Boot mode,
which lasts for approximately four (4) seconds the middle LED is
lit and firmware upgrades can be performed.
8.2 Configuration Mode
After the Boot mode ends the unit LEDs (all 3) will flash
simultaneously 3 times for the duration of 3 seconds at a rate
of: 600on-600off-600on-600off-600on (ms) indicating that the
unit is in configuration mode. Configuration mode last for 30
seconds following the boot mode.
Note:
The Master card is configured using the Desktop Reader
(CP-R25) and the Card programmer and Fingerprint
enrollment. Refer to the AS-B01 SW manual for more
details.
See Configuring the Reader, on page 11, for more on reader
configuration
8.3 Standby Mode
The Reader enters Standby mode:
• After the Boot (reset) and configuration modes
• After the Lockout mode period