Installation manual

Configuring the Reader
Swipe Family Readers Installation Manual Page 11
6 Configuring the Reader
To provide the highest level of security, the Reader is
programmed to validate only Mifare
®
cards whose settings
correspond to the Master card that is used to configure the
Reader. The Master card controls the following settings:
• Card transfer format
• Mifare card Key A value
• LED and buzzer control enable
• Lock-out settings
• Transmission of Card Serial Number (CSN) or card ID from
dedicated sector
Note:
The Master card is configured using the Desktop
Programmer (CP-R25). Refer to the AS-B01 SW manual for
more details.
6.1 Configuration Procedure
It is recommended to configure the Reader one time only,
immediately following installation.
To configure the Reader:
1. Power up the Reader. The middle LED lights continuously for
8 seconds of boot loading. Then 3 long beeps are
generated, and all 3 LEDs flash simultaneously for 3
seconds. The Reader is in Configuration mode.
2. Within 30 seconds (while the Reader is still in Configuration
mode), present a valid Master card to the Reader. If the
configuration was valid, 3 short beep will be emitted, and
all 3 LEDs will flash 3 times at a fast rate, simultaneously. If
the configuration was not valid, an error beep is
generated. The Reader is configured to operate according
to the settings of the presented Master card.