Installation manual

Wiring Instructions
Swipe Family Readers Installation Manual Page 10
5 Wiring Instructions
Mifare
®
Smart Card Fingerprint Swipe Sensor MOC Readers are
supplied with a 7- wire, 18-inch cable.
To connect the Reader to the Controller:
1. Prepare the Reader cable by cutting the cable jacket
back 1¼ inches, and by stripping the wires ½ an inch.
2. Prepare the Controller cable by cutting the cable jacket
back 1¼ inches, and by stripping the wires ½ an inch.
3. Splice the Reader pigtail wires to the corresponding
Controller wires (see Table 1), and cover each connection.
4
.
If the Tamper output is being utilized, connect the purple
wire to the correct input on the Controller.
5. Trim and cover all conductors that are not used.
Table 1: Wiring the Reader to the Controller
Color Wiring
Black/ Shield Ground
Red Vin
Green Data 0
White Data 1
Brown LED control
Orange Buzzer control
Purple Tamper
Note:
• The individual wires extending from the Reader are color-
coded according to the required Wiegand standard.
• When using a separate power supply for the Reader, this
supply and the Controller’s power supply must have a
common ground. A linear power supply is
recommended.
• Attach the cable Shield wire on the Reader to an earth
ground (best), or to a signal ground connection at the
panel or power supply end of the cable. This
configuration is best for shielding the Reader cable from
external interference.