User's Manual

INSTALLERS MENU
HomeLogiX Installer Manual Page 32
• Report Options specifies the event groups that are included in a report. Using
the Menu button, Enable or Disable a group, as required and press Enter to
confirm:
o Alarms (enabled by default)
o Troubles (enabled by default)
o Alerts
o Bypass
o Arm/disarm
o Restore
• Dialing Attempts specifies the number of times the system attempts to dial a
private number before dialing the next specified private number. Using the
Menu button, specify between 1, 2, 3, 4, or 5 dialing attempts press Enter to
save. The default is 3 attempts.
7.6.3. CS Report Setup
This menu enables you to set up the Central Station (CS) report options:
To set up CS report:
Follow these steps:
• CS Report method specifies the reporting method. Using the Menu button,
select one of the following and press Enter to confirm:
o Primary Only(default)
o Alternate
o Secondary
o Both
o Disable
• CS Primary specifies the first telephone number of the first central station to
which the system reports in case of an event, and the primary account code –
the number that identifies your system to the central station. The events
reported are the events specified during setup.
Follow these steps:
Note:
For PABX use the digit followed by "*" and then the full number
o Phone Number, Using the numeric keypad, enter the CS telephone
number, press Enter to save, Press the pound key (#) to delete an existing
number
o Account Code, Using the numeric keypad, enter a code of four digits
and press Enter to confirm
o Report Options specifies the event groups which are included in a report.
Using the Menu button, Enable or Disable a group, as required and press
Enter to confirm:
 Alarms (enabled by default)