User Manual

Security Panel Behavior and Modes of Operation
SP-03V2 User Manual
Page 35
To arm the system to HOME mode:
1. Press . A prompt to enter the code
is heard.
2. Enter the code. The code being entered is
indicated by “*”.
3. The panel starts beeping for the period
configured as the Exit Delay. The
indicator begins flashing red. The user must
now exit the secure area within the Exit
Delay time period.
4. The system is armed. The
indicator
displays solid red.
7.2.2. System Away Mode
In AWAY mode, the system enters Alarm Mode if there is any
zone violation, regardless of perimeter or interior type.
7.2.3. Instant Arming
If Instant Arming mode is enabled (by the installer, during
configuration), the system will skip the exit delay as well as
cancel the entry delay configured, and will initiate the Alarm
instantly causing an alarm to go off upon violation of any zone.
To instantly arm the system:
1. Verify that the system is ready for arming.
2. Press either the Home or the Away arming key.
3. Enter your user code.
4. Press the same arming key once again.
7.2.4. Forced Arming
If Forced Arming is enabled, the system is able to arm when
zones are in violation (open) but not defined as bypassed. The
system treats zones of this type automatically as bypassed
zones for the arming period. These bypassed definitions expire