User Manual

Security Panel Behavior and Modes of Operation
SP-03V2 User Manual
Page 34
• The system exits the Alarm Mode if the alarm is triggered
by an alarm or tampering while the system was disarmed.
• The system enters Alarm Mode if any zone is violated
during entry and exit delay periods, unless the walkthrough
feature is enabled and the violated zones are defined as
walkthrough path.
To arm the system:
1. Press . A prompt to enter the code is
heard.
2. Enter the code. The code being entered is
indicated by “*”.
3. The panel starts beeping for the period
configured as the Exit Delay. The
indicator begins flashing red. The user mu
st
now exit the secure area within the Exit
Delay time period.
4. The system is armed. The
indicator
displays solid red.
7.2.1. System Home Arming
When configuring the system the installer can configure the
Arm Mode to HOME. This enables the user to enter the secured
area within the Entry Delay time and the system automatically
changes being in AWAY mode to HOME mode. The effect is
that all perimeter zones remain armed. During the Entry Delay
time, the system ignores zone violations. When the Entry Delay
time has ended, the system ignores interior zone violations.
Once the system is armed Home, it functions as follows:
• The system enters Alarm Mode immediately on a violation
of a perimeter type zone.
• The system activates an entry delay.
• The system enables switching between arming modes. If
the system is currently Armed Home, it accepts an Arming
Away command and switch modes without disarming.
When the user is at home, the alarm can be set for HOME
mode.