User Manual

Security Panel Behavior and Modes of Operation
SP-03V2 User Manual
Page 33
7.1.2. Alarm Mode Disarmed
When disarmed, the system enters into the following status:
• Alarm Mode for all 24 hour zones
• Alarms trigger only for panic, emergency, fire, 24H audible
and silent conditions.
In the Alarm Mode Disarmed state, the system continuously
checks zone status and remains in the Ready status. This Ready
status determines whether the system is ready to arm. The
system becomes Ready to Arm when zones are either closed
or bypassed, or Force Arming is enabled.
In all other cases, including if the No-Supervision of RF devices
parameter is enabled, the system status is Not Ready. In the
Not Ready condition, the system is unable to arm unless the
system has been configured to arming or if Force Arming is
enabled.
7.2 Arming Options
When the user enters a code or remote command, the system
responds as follows:
• If the code or command (armed away/home, disarmed)
is valid and correctly entered, the arming/disarming
operation succeeds. The system then sends the panel a
signal to sound a confirmation notification or generates a
confirmation sound on the local siren. This can be set to
either enabled or disabled. By default it is enabled.
• On entering a wrong code, the system enables immediate
code re-entry and also signals an error indication to the
user.
• Where there are 5 sequential wrong DISARM code entries,
the system ignores further attempts for 30 seconds before
accepting a new code entries.
Once armed, the system functions as follows:
• The system ignores arming commands, except Disarm,
through either panel, or remote during an alarm condition.
• The system sends error indication signals if zones are either
not ready or not bypassed (assuming that a bypass or
forced options are not enabled).