User Guide

REMOTE AND LOCAL PC PROGRAMMING
SP-03V2 Installation Manual
Page 49
6 REMOTE AND LOCAL PC PROGRAMMING
The SP-03V2 SecuraCare PC application, implements TCP/IP and
modem communication as well as direct USB to USB (type A) local
cable connection*.
Connect the SP-03V2 unit to the PC via any one of the options
above.
The user must choose a communication channel in order to perform
any of the following actions:
• Configure an SP-03V2IP address and port on a local area
network (LAN) – only if TCP/IP communication has been
chosen.
Note:
It is crucial to reset your SP-03V2 Panel after
changing its IP Address and Port Number!
• Choose (without changing) an SP-03V2 IP address and port on
a wide area network (WAN) that differs from the WAN on
which the PC is located – only if TCP/IP communication has
been chosen.
• Upload an existing SP-03V2 configuration
• Download an SP-03V2 configuration, whose settings have
been changed
• View and clear history log, and view alarm event log
• View SP-03V2 monitoring online and perform remote actions
(arm, disarm, bypass, un-bypass, and so forth)
• One-time Actions
• Upgrade SP-03V2 Firmware
For more details regarding PC configuration and actions refer to the
SP-03V2 software manual.
*Check USB connection Availability