User Guide

PROGRAMMING
SP-03V2 Installation Manual
Page 39
If an attempt is made to test a device from a different group of RF
devices, or to test a device that the system does not recognize, the
system beeps with a “negative beep.” After a few seconds of
silence, the system clears any previous test results before it runs
another RF test.
To perform the test:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the M
AINTENANCE
submenu. Press the Enter button to access the submenu.
3. Select RF
TEST.
4. Use the Up and Down buttons to select the test you wish to
perform, press the Enter button to access the test. The available
tests are:
• Test Detectors
• Test Remote Controls
• Test Remote Siren
• Test Keypads
• Test Repeaters
5. Activate the RF unit to send a signal to the unit. The results can
be Strong, Normal, or Low.
6. To exit the RF test mode you must press the Cancel button twice.
Test (LED) Indicators
The indicator test checks the functioning of the two indicator LEDs
(Power Status and Communication).
To test the indicators:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the M
AINTENANCE
submenu. Press the Enter button to access the submenu.
3. Select T
EST INDICATORS.
4. Press the Enter button to confirm. The LEDs will blink three (3)
times.