User Guide

PROGRAMMING
SP-03V2 Installation Manual
Page 34
2. Use the Up and Down buttons to locate the COMMUNICATIONS
submenu. Press the Enter button to access the submenu.
3. Select LAN
PARAMETERS.
4. Follow these steps:
• DHCP – Determine whether to use automatic or manual IP
address. Use the Up and Down buttons to choose E
NABLED or
D
ISABLED and press Enter to confirm.
• Subnet IP – Using the keypad enter the subnet IP address and
press Enter to confirm.
• Gateway IP – Using the keypad enter the gateway IP address
and press Enter to confirm.
• Local IP – Using the keypad enter the local IP address and
press Enter to confirm.
• Local port – Using the keypad enter the local port desired and
press Enter to confirm. Local port range is between 1 and
65535.
Line Test
Enables you to specify the time when the telephone line and CS
reporting is tested and reported to the central station, as well as the
number of days between each test (CS periodical reporting).
To set up line test:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the C
OMMUNICATIONS
submenu. Press the Enter button to access the submenu.
3. Select L
INE TEST.
4. Use the Up and Down buttons to select between the two options,
and press Enter to confirm:
• Repeats, specifies the number of days between tests. Using the
numeric keypad, choose 1 to 30 days press Enter to save;
default is 7 Days.
• Test Time Using the numeric keypad, specifies the time of day
(24-hour day convention) to perform the test by typing the four
digits of the desired hour, press Enter to save. The test time is set
at 12:00 by default.