User Guide

PROGRAMMING
SP-03V2 Installation Manual
Page 33
the events specified during setup. Follow the instructions in CS
Primary to set the secondary account.
• CS Primary Protocol, specifies the reporting protocol used by
the system to report events to the primary central station.
Currently either Contact ID (over Phone Line), or Contact ID IP
(over Ethernet) are available.
• CS Secondary Protocol, specifies the reporting protocol used
by the system to report events to the secondary central station.
Currently either Contact ID (over Phone Line),or Contact ID IP
(over Ethernet) are available.
• Dialing Attempts specifies the number of times the system
attempt to dial the primary stations number before attempting
to dial the secondary number. Use the Up and Down buttons to
specify between 1, 2, 3, 4, 5 or 6 dialing attempts press Enter to
save. The default is 3 attempts.
• 2-Way voice allows the CS to open a two-way voice
communication with the panel in case of trouble event for a
predetermined time period.
o CS 2-way voice – Use the Up and Down buttons to choose
E
NABLED or DISABLED and press Enter to confirm.
o 2WV Timeout – Use the Up and Down buttons to select the
timeout period between 30 Sec, 1 Min, 2 Min, 3 Min, or 4
Min and press Enter to save.
Note:
Changing TCP/IP values resets the system.
LAN Parameters
There are two communication types enabled for connecting the AR-
P103 Software application to the SP-03V2 Elderly Care Telephone
panels. The optional communication types are via modem or TCP.
The TCP/IP is detected and configured automatically, for manual
configuration of the TCP/IP connection use the LAN parameters
menu.
To manually configure the LAN parameters:
1. Access the Installer menu as explained on page 16.