User Guide

PROGRAMMING
SP-03V2 Installation Manual
Page 32
o Phone Number, Using the numeric keypad, enter the CS
telephone number, press Enter to save. Press the pound
key (#) to delete the last entered digit.
Note:
For PABX use the digit followed by "*" and then the
full number
o Receiver IP Address – Enter the call center’s IP address.
The IP value is a string of four sets of 3 digits separated by a
period. The acceptable value is between 0-255. The
system automatically ads the period between strings, but
the number must be complete. E.g. 001.010.100.100
o Primary Receiver Port Number – Enter the call center’s Port
Number, the value of the port number is either 5 or 6 digits
long.
o Primary Account Code, Using the alphanumeric keypad,
enter your CS identification code and press Enter.
Note:
The identification code can be 4 (ADEMCO Contact ID), up to
6 digit long and can contain numeric values 0-9 and
alphabetic values A, B, C, D, E and F. (for ADEMCO Contact ID
value A is disabled)
Press the alphanumeric buttons (keys 2-9) repeatedly to scroll
between the numeric and alphabet values.
o Report Options specifies the event groups which are
included in a report. Use the Up and Down buttons to
Enable or Disable a group, as required and press Enter to
confirm:
§ Alarms (enabled by default)
§ Troubles (enabled by default)
§ Alerts
§ Bypass
§ Arm/Disarm
§ Restore
• CS Secondary specifies the secondary telephone number,
account code and IP configuration. The events reported are