User Guide
Table Of Contents
- 1 INTRODUCTION
- 2 SP-03V2 OVERVIEW
- 3 SPECIFICATIONS
- INSTALLATION
- 5 PROGRAMMING
- 6 REMOTE AND LOCAL PC PROGRAMMING
- 7 READING THE EVENT LOG
PROGRAMMING
SP-03V2 Installation Manual
Page 31
• Dialing Attempts specifies the number of times the system
attempts to dial a private number before dialing the next
specified private number. Use the Up and Down buttons to
specify between 1, 2, 3, 4, 5 or 6 dialing attempts press Enter to
save. The default is 3 attempts.
• 2-Way voice enable or disable the option for two-way voice
user reporting
CMS Report Setup
The installer can specify the various dialing options and number of
contact attempts to the CMS, when the system cannot send the
message to the CMS for any reason, it will reattempt to send the
report for the number of times specified by the installer.
This menu enables you to set up the Central Monitoring Station (CMS)
report options:
To Set Up CMS Report Options:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the C
OMMUNICATIONS
submenu. Press the Enter button to access the submenu.
3. Select CS
REPORT SETUP.
4. Follow these steps:
• CS Report method specifies the reporting method. Use the Up
and Down buttons to select one of the following and press
Enter to confirm:
o Primary Only
o Alternate
o Secondary
o Both
o Disable(default)
• CS Primary specifies the primary telephone number, account
code and IP configuration of the first central station to which
the system reports in case of an event.
Follow these steps: