User Guide

PROGRAMMING
SP-03V2 Installation Manual
Page 27
2. Use the Up and Down buttons to locate the SECURITY submenu.
Press the Enter button to access the submenu.
3. Select D
URESS CODE.
4. Type a new four-digit duress code using the numeric keypad and
press Enter to save your new code.
To Disable the Duress Code:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select D
URESS CODE.
4. Press the pound key (#), the code will disappear, and the duress
code option will be disabled, press Enter to save.
Alarm Cancel
Specifies the amount of time during which if the user disarms the
alarm, the system sends a “Cancel Alarm” message to the central
station. By default, The A
LARM CANCEL is set to 00 minutes (disabled).
To set the Alarm Cancel:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select A
LARM CANCEL.
4. Using the numeric keypad, set the alarm cancel time between
01 – 99 minutes, or set it to 00 to disable the option.
Alarm Abort Time
The system will sound a warning, but the central station will not
receive notification of the alarm if the user disarms the system within
the specified alarm abort time. This function applies to interior and/or
perimeter zones only. The default is set to 00 minutes (disabled).