User Guide

PROGRAMMING
SP-03V2 Installation Manual
Page 25
Enable Forced Arm
Forced Arm allows you to arm the system even if the system is not
ready, under the condition that all open zones will be closed by the
end of the Exit delay. If the zone/s is open when the exit delay
expires, an alarm is generated
To Enable Forced Arming:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select E
NABLE FORCED ARM.
4. Use the Up and Down buttons to choose E
NABLED or DISABLED and
press Enter to confirm.
Quick Arm
Enables the user to arm the system without entering a code; Quick
Arm is set to disable by default.
To Enable/Disable Quick Arming Without a Code:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select E
NABLE QUICK ARM.
4. Use the Up and Down buttons to choose E
NABLED or DISABLED and
press Enter to confirm.
Instant Arm
Enables the user to instantly arm the system by bypassing the Exit
Delay; Instant Arm is set to disable by default.
To enable/disable the Instant Arm option:
1. Access the Installer menu as explained on page 16.