User Guide

PROGRAMMING
SP-03V2 Installation Manual
Page 24
4. Use the Up and Down buttons to select one of the following
options and press Enter to confirm:
• 1, 2, 5, 10, 15, or 30 minutes
• Disable the timer
Note:
Required zones should be set to ‘Enabled’ for this security
feature to work
Enable Trouble Beeps
Determine whether the system will emit a series of four short beeps
once a minute for the following “trouble” events: Low battery
(SP-03V2 unit and detectors), Supervision loss (detectors), Power
failure (SP-03V2 unit), Communication failure (SP-03V2 unit), Tamper
(SP-03V2 unit and zones), and RF jamming The default is set to
Disabled.
To Enable Trouble Beeps:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select E
NABLE TROUBLE BEEPS.
4. Use the Up and Down buttons to choose D
AY, DAY & NIGHT or
D
ISABLED and press Enter to confirm.
Bypass Option
Enables or disables zone bypassing of individual zones, to be later
mapped and defined in the master menu.
To Set Bypass options:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select B
YPASS OPTION.
4. Use the Up and Down buttons to choose E
NABLED or DISABLED and
press Enter to confirm.