User Guide

PROGRAMMING
SP-03V2 Installation Manual
Page 22
To Specify the Siren Mode:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select A
UTO ARMING.
4. Use the Up and Down buttons to select either A
WAY or AWAY +
HOME and press Enter to confirm.
Local Siren
Specifies whether an activated alarm causes an internal siren
(emitted from the system’s speaker) to sound or remain silent. The
local siren is enabled by default.
To Set Up a Local Siren:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select L
OCAL SIREN.
4. Use the Up and Down buttons to select either E
NABLED or DISABLED
and press Enter to confirm.
Supervision Time
Specifies the time limit during which the system receives supervision
reports from specified wireless devices. If a device does not report-in
at least once within the specified time limit, the system initiates an
inactivity alert. Default is set to one hour.
To Specify the Supervision Time:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select S
UPERVISION TIME.