User Guide

PROGRAMMING
SP-03V2 Installation Manual
Page 20
Entry Delay
An entry delay enables the user to enter the site through a specified
door without setting off an alarm. The entry delay is set at 30 seconds
by default.
After entry, the user must disarm the system before the entry delay
expires. Slow-rate warning beeps sound upon detection of the
specified zone/s, the beeping rate increases during the last ten
seconds of the delay.
To Specify the Entry Delay:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select E
NTRY DELAY.
4. Using the numeric keypad, specify the length of time for the entry
delay between 1 and 99 seconds and press Enter to save your
selection.
Note:
Use the # key to delete a digit entered by mistake.
Auto Arming
Auto Arming allows scheduled arming and disarming of the system
for all weekdays at different hours.
To Activate Auto Arm:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the S
ECURITY submenu.
Press the Enter button to access the submenu.
3. Select A
UTO ARMING.
4. Use the Up and Down buttons to select the day of the week and
press Enter to confirm.