User Guide

PROGRAMMING
SP-03V2 Installation Manual
Page 18
5.2.3 Enrolling Wireless Devices and Remote Controls
You can enroll up to sixteen (16) detectors, eight (8) remote controls,
four (4) remote sirens, four (4) keypads, and four (4) repeaters. The
enrollment process can also be done via the software, refer to the
software manual for further details.
Before enrolling wireless devices, the installer should determine
whether the working frequency of the wireless devices is H (868 MHz)
or G (433 MHz). The installer should also be sure that all of these
wireless devices contain the appropriate batteries.
To Enroll a Wireless Device or Remote Control:
1. Access the Installer menu as explained on page 16.
2. Use the Up and Down buttons to locate the E
NROLLING submenu.
Press the Enter button to access the submenu.
3. Select a group of wireless devices:
DETECTORS, REMOTE CONTROLS, R.
SIRENS
, KEYPADS, or REPEATERS.
4. Choose the device number to enroll within the selected device
group.
5. If a device exists, the system will display the following message:
Enter to Delete. To replace the device with a new device, press
Enter to delete, and continue with Step 4, above.
6. If a device does not exist, the system will display the following
message: Waiting for Signal. The system will wait for an event to
be sent from a wireless device (e.g., Tamper, Alarm).
7. If the system receives an event from any wireless device, the
system will provide an audible acknowledgement of receipt, and
will display the following message: Enter to Store.
8. After you press Enter, the system will be ready to enroll the next
wireless device.