User Guide
Table Of Contents
- 1 INTRODUCTION
- 2 SP-03V2 OVERVIEW
- 3 SPECIFICATIONS
- INSTALLATION
- 5 PROGRAMMING
- 6 REMOTE AND LOCAL PC PROGRAMMING
- 7 READING THE EVENT LOG
INSTALLATION
SP-03V2 Installation Manual
Page 14
Figure 2: Rear of SP-03V2 Showing Battery Door
2. Carefully insert a flat screwdriver in the slot under the screw-hole
tab, and twist to lift the tab off the main housing. Alternatively,
you may use your finger to pull off the battery lid.
Note:
Be particularly careful not to lose the screw, or damage the
battery door unit.
Do not try to remove the battery door from the catches without
removing the screw, and do not over tighten the screw
3. Inside the battery compartment, you will see a battery
connector on the PSB.
Figure 3: Battery Compartment Interior