User's Manual

Installation
Page 17 SA-80A Installation Manual
5.3 Testing
It is necessary to check the general operation of the siren, and to
test it after installation and prior to putting it into service.
5.3.1. General Operation
Make sure that power is applied to the siren. Observe that the
green light on the Strobe board is illuminated.
Before beginning, read the entire process!
5.3.2. Testing
The following steps are performed with a telephone unit, type SP-
03, and its remote control; the phone’s frequency is to match that
of the siren.
Perform the steps listed in the table below.
Table 2: Testing Wireless Siren
Step Operation
Audio
Indication
Visual
Indication
1
Connect power to
the telephone; do
not connect a
phone line.
The phone
emits two
short beeps.
SP03 V1.2 WAIT
2
Enter 8 8 8 8 on the
phone.
A beep is
emitted
after each
digit is
entered;
* * * * followed
by,
PROGRAMMING
SELECT
FUNCTION
3
Press the Å key.
The phone
emits two
short beeps.
WIRELESS SIRENS
NOT INSTALLED
4 Press Store key. SIREN TIME: 03