User's Manual

Installation
2) Locate the feed hole and grommet for the wires to be
connected inside the unit (see Figure 6); two 22 AWG cabling
wires are needed for the 16 VDC power.
3) Use a simple wire loop to pull the cabling through the hole into
the base area. Leave enough slack to make connections to
the Main board.
4) Run the cabling via the rubber grommet, and replace the
grommet in the base.
5) Secure the cabling by using the holding clamp (see Figure 6).
6) Strip the cable and wires and connect the power conductors
to the power input terminals J1 (-16VDC+) (see Figure 7).
Observe polarity!
7) Once all wiring has been done, locate and connect the red
battery wire to the battery positive lug and the black wire to
the negative lug. Do not apply external power at this time.
Note:
The siren is not powered after the battery is connected. The
unit starts operating only after external power from a wall
adapter or from the host panel is applied.
8) Check the operation of the tamper switch, as indicated
hereafter.
5.2.4. Tamper Switch Setting
You can adjust the plunger to compensate for an uneven
mounting surface. You can perform the adjustment using the
screw within the plunger (see Figure 8). Releasing the plunger
activates the micro-switch (alarm condition), until the cover is
replaced.
Reconnect the speaker connector to J5 on the Main board (see
Figure 7), prior to closing the cover.
SA-80A Installation Manual Page 15