User's Manual

Installation
Rubber
Gasket for
Tamper
Switch
(+3 places)
Rubber
Gasket for
Mounting
Hole
Figure 5: Base with Sealing Gaskets
5.2.2. Initial Preparation
1) Disassemble the cover from the base by extracting the three
screws from the cover. Set the screws aside.
2) Use the dimensions from Figure 6 to locate the three holes to
be drilled in the wall. As an alternative, the base can be
positioned, and the holes marked.
3) Use appropriate hardware to affix the base to the surface.
4) Make sure that the straight side of the base is level.
SA-80A Installation Manual Page 13