User's Manual

Installation
Table 1: Main Board Jumper Settings
Jumper Function Fitted
Not
Fitted
Remarks
JP1
Volume
selection
Low High (1)
JP2
Input
topology
N.C. N.O. Alarm input
JP3
Alarm
timer
15 min. 5 min.
JP4
Not used
For factory
programming
only
Note:
Volume settings are according to section 4 Technical
Specifications.
5.2 Mechanical Installation
5.2.1. Preferred Location
Mount the siren unit on a straight surface, away from heat or
exhaust of gases, and preferably in a shady place. The unit is
protected from rain and dust by a gasket surrounding the base of
the unit to seal the cover, and by gaskets that surround each
entry hole in the base (see
Figure 5). The unit may be installed in
any one of four directions, as desired by the installer. However, for
the SA-80 G range models, it is recommended to install the unit in
an upright or downright position (as portrayed in Figure 1 and
Figure 6) for optimal RF reception.
Page 12 SA-80A Installation Manual