User's Manual

Installation
5. Installation
This section provides details and procedures on the physical and
electrical installation of the siren unit. The unit is first physically
installed, and then a number of steps are followed to enable and
arm the device.
5.1 Jumper Settings
It is recommended to set the jumpers before installing the unit, as
it is much easier than doing so after installation.
1) Disassemble the cover from the base by extracting the three
screws from the cover. Set the screws aside.
2) Locate the Main board and identify the jumpers to be set,
according to Figure 4 and Table 1.
Figure 4: Setting Jumpers on Main Board
SA-80A Installation Manual Page 11