User's Manual

4. PYR-2011G Features
• Advanced micro-controller electronics: 10-bit A-to-D and
advanced algorithms for superior movement speed spectrum
analysis
a dust-proo hamber
tion against
n without PCB
•
•
•
• ’s
•
• Shielded dual-element Pyro: Inside
designed to reduce thermal chan
f c
ges and insect protection
• Three levels of sensitivity: High, medium or low; by jumper
selection
• Power saving: Two transmission modes by jumper
• Back and Front Cover tamper switches: Protec
cover or wall removal for higher security.
• Easy & comfortable installation: Easy installatio
adjustment.
Easy Walk & Radio test: By single contactless switch.
Energy detection system: By using fuzzy logic algorithms,
detection is improved and false alarms are reduced
Environment temperature compensation: Maintains constant
detection capability
Adaptive filter: Compensates for changes in a detected object
speed
Continuous monitoring: Sends visual alerts in case of malfunction
(digital & analog) and temperature out of range
5. Installation
in section 5.
described
The PYR-2011G housing can be opened by unscrewing a Philips-
head screw (1) and pushing the safety h (2) to “unlock”.
5.3 Mounting the PYR-2011G PIR
Select an area for mounting the PYR-2011G, and ensure the
location is flat, either a wall or a 90-degree corner, for perfect
mounting of the unit. Ensure the PIR has a “view” of the area
plastic
bracket in the Corner, at the exact chosen location. Pay
attention, the Brack a Direction, the narrow edge faces
downwards. Next, attach it firmly to the wall; all 4 screws must be
inserted. Now inset the Body of the PYR into place over the
plastic bracket, using the corner mounting holes. If the installation
is done properly the pl pipe/pole will press the “back
tamper” correctly.
5.1 General
The PYR-2011G is designed for easy installation. Only a few steps
are required to install the PIR device.
To enable the Curtain Adapter for PIR detection on a focused
area, such as a corridor, or across a window or opening, follow
the instruction outlined
When you are sure of the mounting location, follow the steps for
mounting the PIR, on a flat surface or in a corner,
below.
5.2 Opening the PYR-2011G
under surveillance and is free from obstructions.
The PYR-2011G has a detection range of 14.7m (48 ft.) when
placed at a height of between 1.8m and 2.3m.
When using the Corner Mount, first of all place the
et has
astic
latc
1
2
2 0706-0960110+01