User's Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Operating the HLX-24
- 4. System Overview
- 5. User Menu Structure
- 6. Telephony Voice Response Menu
- 7. Reading the Event Log
- 8. User Menu Options
- 8.1 Accessing the User Menu
- 8.2 Changing the Master Code
- 8.3 Defining User Codes
- 8.4 Authorization Codes
- 8.5 Silent Exit
- 8.6 Setting Date and Time
- 8.7 Defining Date and Time Format
- 8.8 Setting Zone Bypass
- 8.9 Enrolling a Remote Control
- 8.10 Deleting a Remote Control
- 8.11 Setting Phone Numbers
- 8.12 Registration Code (HLX-24IP model only)
- 9. Maintenance
- A. Declaration of Conformity
- B. Limited Warranty
System Overview
HLX-24 User Manual 17
Table 3: Display Options
System Status
Ready
Indicates that all zones are in Normal state and the system is ready
for arming.
Not ready
Indicates that at least one zone is open and the system is not ready
for arming.
Press Enter to see which zones are open. If there is more than one
open zone, pressing Enter or Menu displays the next open zone.
When there are no more open zones, the display returns to the idle
view. You can also exit the active zone view by pressing the ESC,
Away or Home buttons.
Event Display
TRBL
Indicates that a problem exists on the system. The following
System
Troubles
may appear in the TRBL message:
• Battery Missing
• Dead Battery
• Low battery
• Power failure (AC Fail)
• RF jamming
• Line Fail
• Communication Fail
• Tamper
In addition, the following Zone Troubles may appear in the TRBL
message:
• Tamper
• Low battery
• Supervision (failure)
MEM Indicates an alarm in memory
LOG Indicates that a trouble event appears in the log file
ABT Indicates that at least one zone alarm aborted
CNL Indicates that a cancel alarm was transmitted to the central station
MSG Indicates that a personal message is waiting