User's Manual

Installer Menu
50 HLX-24 Hardware Installation and Programming Manual
To perform the test:
1. Using Menu select the test you wish to perform, and press Enter to
access the test.
2. Activate the RF unit to send a signal to the unit. The results can be
Strong ,
Normal or Low . The available tests are:
 Test Detectors (Walk Test) (refer to Table 11)
 Test R. Controls
 Test R. Siren
 Test Keypads
 Test Repeaters
To view the results:
1. For each of the tests, you can review the results by pressing Enter and
then either Menu or the alphanumeric keys review all the units.
2. To exit the RF test mode you must press ESC.
6.8.3 Test Indicators
The indicators test checks the two indicator LEDs, power and status, located on
the Panel.
To test the indicators:
After entering this menu, press Enter. The LEDs blink three times.
6.8.4 Sirens Test
This test checks the different available sirens by activating them.
To test the sirens:
1. Select the siren you wish to test:
 Local Siren
 Wireless siren
 Siren 1
 Siren 2
 Siren 3
 Siren 4
2. Press Enter to activate the sounder.
3. Press ESC to stop the siren.
6.8.5 Test Devices
This test checks the PGM connected to the system.
To test the PGM devices:
1. Select the PGM test
2. Press Enter to activate the PGM for three seconds.