User's Manual

Installer Menu
HLX-24 Hardware Installation and Programming Manual 43
5. Dialing Attempts – Specify the number of cycles the panel goes through
while attempting to connect to a remote private phone, where a cycle
consists of up to 3 different remote private phones. The default is 3
attempts.
a. Using the numeric keypad, enter the dialing attempts value between
1 and 15.
b. Press Enter to save.
6.5.3 CS Report Setup
This menu allows you to set the Central Station (CS) report options.
To set up CS report:
1. Using Menu, select each of the following submenus and press Enter to
confirm:
a. CS Report Method – Specify the reporting method.
i. Using Menu, select one of the following:
o Disable (default)
o Primary Only
o Alternate
o Secondary Only
o Both
ii. Press Enter to confirm.
b. CS Primary – Specify the first telephone number of the first central
station to which the system reports in case of an event as well as the
primary account code and report options. Under this menu, you must
set the following parameters:
 Phone Number – The primary CS telephone number
i. Using the numeric keypad, enter the primary CS telephone
number.
ii. Press Enter to confirm. Use * to enter a comma. Use # to
delete the last digit.
For PABX, use the digit followed by * and then the full number.
 Account Code – The number that identifies your system to the
central station. The account code range is 0–9, B, C, D, E, and F.
i. Using the alphanumeric keypad, enter a code of four
digits/letters.
ii. Press Enter to confirm.
 Report Options – Specify the event groups that are included in
a report.