User's Manual

Installer Menu
HLX-24 Hardware Installation and Programming Manual 37
For a signal to be sent to the CMS, the Alerts reporting group must be enabled
in Report Options (Section 6.5.3).
To set the Alarm Cancel:
1. Using the numeric keypad, set the alarm cancel time between 01 to 10
minutes or 00 to disable the option.
2. Press Enter to confirm.
6.4.19 Alarm Abort Time
The system sounds a warning, but the central station does not receive
notification of the alarm if the user disarms the system within the specified
alarm abort time. This function applies to interior, perimeter, and 24-hour
zones. The default
Alarm Abort Time is 30 seconds.
To set the alarm abort time:
1. Using the numeric keypad, set the alarm abort time between 01 to 45
seconds or 00 to disable the option.
2. Press Enter to confirm.
6.4.20 Backlight Time
Specifies the backlight options; by default, the backlight time is set to 15
seconds.
To set the backlight:
1. Using Menu, select one of the following options:
 Always: to specify that the keypad and buttons are backlit at all
times.
 15 secs: to specify that the keypad and buttons are backlit for up to
15 seconds after last key press.
2. Press Enter to confirm.
6.4.21 Hide Display
Enables you to specify that when armed, the system does not display the
system statuses or other system prompts; by default,
Hide Display is off.
To display the system status:
1. Using Menu, select one of the following options:
 Off to display status and prompts.
 On to hide status and prompts.
2. Press Enter to confirm.